LED NEON strip 230V
LED NEON strip for 230V with the effect of replacing classic neon, suitable for indoor and outdoor use such as decoration of buildings, stairs, restaurants, casinos, illuminated signs, etc.
LED NEON strips 230V can only be divided into whole meters, the original reels are 50 meters long and only one 200cm power cable or 50cm power cable can be used on these 50 meters. This LED strip has no dimming at 50 meters.
DC voltage is required to connect to 230V, so it is necessary to use this original power cable or rectifier bridge - not included, must be ordered separately
To install more colors, it is possible to use the RGB LED driver, where you can then set different interweaving of up to 3 individual branches, eg between red, green and blue.
Warning
230V LED strips must not be installed in direct sunlight. Even when the strip is switched off, it is then exposed to a high temperature, which greatly reduces the life of the LEDs and can cause material stress, thus damaging the connections and causing the lighting of individual modules to fail.
LED NEON strips for 230V are not suitable for long-term lighting (approx. 6-8 hours a day is acceptable).
This tape is not self-adhesive.
This tape is dimmable by a triac dimmer. For example, you can choose between remote and built-in.
Temperature
- Warm White - 2700-3200K
- White - 6500-7000K
Luminous flux
- Warm white - 600lm / m
- White - 650lm / m
- Red - 300lm / m
- Green - 480lm / m
- Blue - 590lm / m
CRI
- Warm White - 74
- White - 74